Setting Oven Controls; Setting The Clock - Kenmore 790.4661 Use & Care Manual

Setting Oven Controls

Setting the Clock

The CLOCK pad is used to set the clock. The clock may be set for 12 or 24 hour
C
LOCK
time of day operation. The clock has been preset at the factory for the 12 hour operation.
When the range is first plugged in, or when the power supply to the range has been
interrupted, the display will flash with "PF" (power failure, See Figure 1).
When PF appears in the display, press
a beep will sounds and PF will disappear.
INSTRUCTIONS
To set the clock (example below for 1:30)
1. Press . "CLO" will appear in the display (Figure 2).
C
LOCK
2. Press
(Figure 3). "CLO" will stay in the display. Press
will disappear and the clock will start (Figure 8).
Changing between 12 or 24 hour time of day display
1. Press and hold
C
LOCK
3). After 3 seconds
the cooktop lockout is active (Figure 4). CONTINUE holding the
pad until "12Hr" (Figure 5) or "24Hr" (Figure 6) appears in the
display.
F
LEX
2. Press to switch between the 12 and 24 hour time of day
C
LEAN
display. The display will show either "12Hr" (Figure 5) or "24Hr"
(Figure 6).
3. Press S to accept the desired change or press
TART
reject the change (Figure 7).
4. Press and hold
C
LOCK
lockout feature if desired (Figure 8).
5. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
S
TOP
No sound will be heard, but after 10 seconds
.
C
LEAR
pads to set the time of day to 1:30
. "CLO" will appear in the display (Figure
will appear in the display indicating that
until disappears to cancel the cooktop
PRESS
S . "CLO"
TART
for 7 seconds
S
TART
S
TOP
to
C
LEAR
17
DISPLAY
C
LOCK
S
TART
C
LOCK
F
LEX
C
LEAN
S
TOP
or
C
LEAR
C
LOCK
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8