Setting Surface Controls - Kenmore 790.4661 Use & Care Manual

Setting Surface Controls (cont'd)
To Set the Cooktop Lockout Feature
The pad is used to activate the Cooktop Lockout feature which will lock all surface elements from being accidentally
C
LOCK
turned ON. This feature will only lock the cooktop.
INSTRUCTIONS
To turn the Cooktop Lockout Feature ON:
1. BE SURE ALL surface element controls are set to the OFF position.
2. Press and hold
C
LOCK
second beep sounds (after 3 seconds). If a triple beep sounds instead,
check all surface elements and turn them to the OFF position and repeat
this step. will appear in the display indicating the cooktop controls and
functions are locked out until the cooktop is unlocked (See Figure 1).
3. To remove "CLO" from the display, press
(See Figure 2).
To turn the Cooktop Lockout Feature OFF:
1. BE SURE ALL surface element controls are set to the OFF position.
2. Press and hold
C
LOCK
second beep sounds (after 3 seconds). If a triple beep sounds
instead, check all surface elements and turn them to the OFF
position and repeat this step.
indicating the cooktop may be used normally (See Figure 3).
3. To remove "CLO" from the display, press
(See Figure 4).
Note: Starting a Self-Clean cycle will automatically turn ON the Cooktop Lockout feature. The cooktop will remain
locked until the Self-Clean cycle has completed and the oven door has unlocked. If a power failure occurs after the
Cooktop Lockout has been activated, you must turn OFF the Cooktop Lockout feature before being able to use the
cooktop features again.
How the Electronic Surface Element Controls work when the Sabbath feature is ON.
When your Oven Sabbath feature is ON, the Electronic Surface Elements are also in Sabbath mode. This means that all
electronic surface element control displays show "Sb". The surface elements can be used even if the Sabbath Feature is
on.
To turn ON a Surface Element when the Oven Sabbath Feature is active:
If you turn on a surface element when the oven Sabbath feature is on, the electronic surface element control will record
that request and execute it with a 15-30 seconds delay. So the element will start heating 15-30 seconds after the surface
element control was turned on. As the oven control, the surface element display will not show the setting because "Sb" is
on in the displays. When necessary, it is possible to adjust the power of the surface element but you have to remember
that the surface element control will adjust the temperature with the same delay.
To turn OFF the Surface Element when the Oven Sabbath Mode is active:
To shut off the surface element while the Sabbath feature is ON, proceed as usual but take note that the element will
immediately turn off without any delay.
Note: Refer to page 33-34 to activate the Sabbath Feature.
until "CLO" appears. Continue holding until a
S
TOP
C
LEAR
until "CLO" appears. Continue holding until a
will disappear from the display
S
TOP
C
LEAR
C
OOKTOP
or wait 30 seconds
or wait 30 seconds
13
PRESS
C
LOCK
S
TOP
C
LEAR
C
LOCK
S
TOP
C
LEAR
DISPLAY
Figure 1
Figure 2
Figure 3
Figure 4