Enable Ip Pass Through Mode - NETGEAR AirCard 810S User Manual

The default password is admin. The password is case-sensitive.
The Home page displays.
4. Select Settings > Router > Port Filtering.
The Port Filtering page displays.
5. From the Port Filtering list, select one of the following:
• Black List. Specific applications and services are not allowed to access the Internet
(block list).
• White List. Specific applications and services are allowed to access the Internet
(allow list).
Only one list at a time can be active, either a black list or a white list.
6. Identify the ports to filter.
Enter a meaningful label that describes the application or service.
7. Enter the port being used.
8. Enter the communication protocol being used.
The Submit button displays after you make a selection.
9. Click the Submit button.
Your selections are saved.

Enable IP Pass Through Mode

To turn off the hotspot router functionality and assign the network IP address directly to the
attached device, enable IP pass through.
If you make this change, the attached device restarts using a different driver configuration.
WARNING:
If you enable this feature, Wi-Fi is disabled and you must use a USB
cable to tether the device.
Telstra Wi-Fi 4GX Advanced III
Advanced Settings
78