If You Have A Beoline Pstn Base; If You Have Previously Registered Handsets To This Base - Bang & Olufsen BeoCom 6000 Manual

If you have a BeoLine PSTN base...

> Ensure that the base and the charger are connected to the mains.
> Press and hold the button on the back of the base for at least four
seconds. The base is now open for registration for five minutes.
> If you are registering your first handset to this base, place the handset
in the charger. Registration occurs automatically, and you can then
name the handset, as described on page 9.

If you have previously registered handsets to this base...

REGISTER BASE?
OK
BASE 01/01
36-000077123456
OK
0 – 9
OK
Press to switch on the handset
Press to be able to register the handset.
REGISTER BASE? is shown in the display
Press to continue. The handset searches for an
open base
When a base is located, the PARK number
identifying the base is shown. Check the number
against the number on the back of the base
If the numbers do not match, turn the wheel to
view the available bases. If the desired base is
not shown, open the base for registration once
more and repeat the procedure. Otherwise...
Press to register the handset to the base
If the base prompts you for a PIN code, enter the
PIN code and press OK. The display tells you
when registration is complete
Button
The BeoLine PSTN base. The PARK
number identifying the base is
visible on the back. Check this
number against the number in the
handset display.
If you have registered a handset to
more than one base, you must
select which base you want to use.
Refer to page 48 for further
information.
You can not edit in common
Phonebook, Caller ID or Redial lists
if you register a common handset
to more than one base. Set your
handset to 'personal' if you intend
to register it to more than one
base. Refer to page 34 for further
information.
7