Configuring The System Settings (Advanced Setup Menu); Advanced Setup Menu Items; Changing The Speaker Impedance Setting (Sp Imp.); Selecting The Remote Control Id (Remote Id) - Yamaha R-N602 Owner's Manual

Configuring the system settings (ADVANCED SETUP menu)

Configure the system settings of the unit while viewing the front display.
1
Turn off the unit.
2
While holding down RETURN on the front
panel, press A (power).
A (power)
DIMMER DISPLAY MODE MEMORY
INPUT BASS
PHONES SPEAKERS
A B
5V 1A
DISPLAY
3
Rotate SELECT/ENTER to select an item.
4
Press SELECT/ENTER to select a setting.
5
Press A (power) to set the unit to turn off and
turn it on again.
The new settings take effect.

ADVANCED SETUP menu items

Item
Changes the speaker impedance
SP IMP.
setting.
Selects the unit's remote control ID.
REMOTE ID
Restores the default settings.
INIT
Updates the firmware.
UPDATE
Checks the version of firmware
VERSION
currently installed on the unit.
RETURN
PURE DIRECT
CLEAR BAND PRESET TUNING
VOLUME
TREBLE BALANCE LOUDNESS SELECT
PUSH - ENTER
FLAT
-30dB
RETURN
CONNECT
L R
SELECT/ENTER
Function Page
47
47
47
48
48
Changing the speaker impedance
setting (SP IMP.)
SP IMP.••8¬MIN
Change the unit's speaker impedance settings depending
on the impedance of the speakers connected.
Settings
Select this option when you connect speakers with
4  MIN
an impedance of 4 ohms to less than 8 ohms to the
unit.
8  MIN
Select this option when you connect speakers with
an impedance of 8 ohms or more to the unit.
(Default)
Selecting the remote control ID
(REMOTE ID)
REMOTE ID•AUTO
When using multiple receivers in the same room, setting
the remote control ID of this unit to ID1 (and setting the
another receiver to other than ID1 can prevent interference
from other remote controls.
Settings
ID1, AUTO (default)

Restoring the default settings (INIT)

INIT••••CANCEL
Restores the default settings for the unit.
Choices
Restores the default settings for the unit.
ALL
Initialize all of the network, Bluetooth and USB
settings. When performing the initialization, the
NETWORK
preset (p. 41) registered by NET/USB input will
be cleared.
Does not perform an initialization.
CANCEL
47
En