Table of Contents
Advertisement
6
Appliance Preparation
A. Top to Rear Vent conversion
This model comes from the factory set up for a top vented
application. To vent this model from the rear, follow the
conversion instructions below. If venting off the top, no
further preparation is needed. Proceed to next section.
See Service Parts list in Owner's Manual for Kit information.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during
installation. Sheet metal edges are sharp.
Included in Kit: Rear vent grille, NG Orifice (#33), LP Orifice
(#54)
Tools Required: Power drill, 1/4 in. hex driver bit, #2 Phillips bit,
3/8 in. open end wrench, high temperature sealant (if required)
Note: See appliance Installation Manual for proper venting
configurations.
1. Remove top grille, as highlighted in Figure 6.1.
Figure 6.1
2. Remove starting collar and gasket by removing 4 screws.
See Figure 6.2. Save the screws. (If gasket breaks, apply
high-temp sealant to bottom of collar before installing as
shown in Figure 6.8.)
Figure 6.2
32
Heat & Glo • TIARII-BK-IPI, TIARII-BR-IPI, TIARII-CES-IPI Installation Manual • 2340-980_R9 • 06/15
3. Remove the inner pipe adapter shown in Figure 6.3
by removing six screws. Remove gasket and discard.
Replace six screws into holes and tighten.
INNER PIPE
ADAPTER
REMOVE
ScREwS (6)
Figure 6.3
4. Locate the knock out on rear of appliance. Break the
seal on the knock out and discard the knock out.
REMOVE
KNOcKOuT
Figure 6.4
Advertisement
Table of Contents
