Connecting The Stylus Scan To Your Computer; Using The Parallel Port (For Windows 98 Or 95) - Epson SylusScan 2000 Setup Manual

c
3. If the power cord is not attached to the Stylus Scan, connect it
to the AC inlet at the back of the Stylus Scan.
4. Plug the power cord into a properly grounded electrical
outlet.

Connecting the Stylus Scan to Your Computer

Your Stylus Scan has two ports through which it can be connected
to a computer; a parallel port and a USB port. Use the port
appropriate for your computer.
Note:
If your computer has both a parallel and USB port, be sure to follow
the correct steps to connect to the desired port.
Do not use the Stylus Scan's parallel port and USB port
simultaneously. Connect the Stylus Scan to one computer at a time.

Using the parallel port (for Windows 98 or 95)

To connect the Stylus Scan to your PC using the parallel port, you
need a shielded, twisted-pair parallel cable. Follow the steps
below to connect your Stylus Scan via the parallel port.
1. Make sure both the Stylus Scan and computer are turned off.
2
Caution:
It is not possible to change the Stylus Scan's voltage. If the
rated voltage and your outlet voltage do not match, contact
your dealer for assistance. Do not plug in the power cord.