Using The Usb Port (For Windows 98 Or Macintosh) - Epson SylusScan 2000 Setup Manual

2. Plug the cable connector securely into the parallel interface
connector at the rear of the Stylus Scan. Squeeze the wire clips
together until they lock in place on both sides.
3. Plug the other end of the cable into the computer's parallel
interface. If there is a ground wire at the computer end of the
cable, connect it to the ground connector at the back of the
computer.
You are now ready to install the Stylus Scan drivers. For
installation instructions, see "For Windows 98 and 95 with a
parallel connection" on page 5.

Using the USB port (for Windows 98 or Macintosh)

To connect the Stylus Scan to your computer using the USB port,
you must first install the Stylus Scan drivers.
See "For Windows 98 with a USB connection" on page 9 to install
the drivers and connect the Stylus Scan to your Windows 98
computer using the USB port.
To install the software and connect the Stylus Scan to your
Macintosh, see "Installing the software in your Macintosh" on
page 17.
3