Plugging In The Stylus Scan; Connecting The Stylus Scan To Your Computer - Epson STYLUS SCAN 2500 Manual

Plugging in the Stylus Scan

1. Make sure that the Stylus Scan is turned off.
2. Check the label on the back of the Stylus Scan to make sure
the voltage required by the Stylus Scan matches that of the
your electrical outlet. Also, make sure that you have the
correct power cable for your power source.
c
3. If the power cord is not attached to the Stylus Scan, connect it
to the AC inlet at the back of the Stylus Scan.
4. Plug the power cord into a properly grounded electrical
outlet.

Connecting the Stylus Scan to Your Computer

Your Stylus Scan has two ports through which it can be connected
to a computer; a parallel port and a USB port. Use the port
appropriate for your computer.
Note:
❏ If your computer has both a parallel and USB port, be sure to follow
the correct steps to connect to the port you choose.
❏ Do not use the Stylus Scan's parallel port and USB port
simultaneously. Connect the Stylus Scan to one computer at a time.
Caution:
It is not possible to change the Stylus Scan's voltage. If the
rated voltage and your outlet voltage do not match, contact
your dealer for assistance. Do not plug in the power cord.
7