Table of Contents
Advertisement
Attaching the Paper Support
The EPSON Stylus Scan comes with two paper supports.
Paper support (gray)
Fit the paper support into the slots at the rear of the Stylus
Scan.
Document support (transparent)
Carefully fit the document support into the holes at the rear
of the Stylus Scan.
document support
Plugging in the EPSON Stylus Scan
1. Make sure that the Stylus Scan is turned off. It is off when the
P power button protrudes slightly from the surface of the
control panel.
2. Check the label on the back of the Stylus Scan to make sure
the voltage required by the Stylus Scan matches that of the
electrical outlet you plug it into. Also, make sure that you have
the correct power cable for your power source.
paper support
1
Advertisement
Table of Contents
