Front Bezel Security - HP EliteDesk 800 G2 SFF Maintenance And Service Manual

Front bezel security

The front bezel can be locked in place by installing a security screw provided by HP. To install the security
screw:
1. Prepare the computer for disassembly
2. Remove the access panel
3. If you do not have a 6-32 standard screw, remove one of the four silver 6-32 standard screws located on
top of the drive cage. Refer to
standard screw locations.
4. Install the 6-32 security screw through the middle front bezel release tab to secure the front bezel in
place.
5. Replace the computer access panel.
6. If the computer was on a stand, replace the stand.
7. Reconnect the power cord and any external devices, and then turn on the computer.
8. Lock any security devices that were disengaged when the access panel was removed.
20 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
(Preparation for disassembly on page
(Access panel on page 19).
Installing and Removing Drives on page 33
18).
for an illustration of the 6-32