Expansion Card - HP EliteDesk 800 G2 SFF Maintenance And Service Manual

Expansion card

Description
nVIDIA GT730 2 GB graphics card (DDR3, PCIex8)
USB 3.1 Type Cx1 PCIe x1 card
Printer port, PCI card
Serial port, PCI card
WLAN module caddy card
The computer has two PCI Express x1 expansion sockets, one PCI Express x16 expansion socket, and one PCI
Express x16 expansion socket that is downshifted to a x4 socket.
NOTE: The PCI Express sockets support only low profile cards.
You can install a PCI Express x1, x4, x8, or x16 expansion card in the PCI Express x16 socket.
For dual graphics card configurations, the first (primary) card must be installed in the PCI Express x16 socket
that is NOT downshifted to a x4.
To remove, replace, or add an expansion card:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Locate the correct vacant expansion socket on the system board and the corresponding expansion slot
on the back of the computer chassis.
4. Release the slot cover retention latch that secures the slot covers by lifting the tab on the latch and
rotating the latch to the open position.
5. Before installing an expansion card, remove the expansion slot cover or the existing expansion card.
NOTE:
the expansion card.
(Access panel on page
Before removing an installed expansion card, disconnect any cables that may be attached to
(Preparation for disassembly on page
19).
18).
Expansion card 25