Installing A 2.5-Inch Hard Drive - HP EliteDesk 800 G2 SFF Maintenance And Service Manual

5. Pull outward on the release lever at the rear of the drive (1) then slide the drive back until it stops and
pull it down and out of the drive bay (2).
6. If you are installing a new drive, refer to
installing a new drive, rotate the drive cage down and replace the access panel.

Installing a 2.5-inch hard drive

1. Prepare the computer for disassembly
2. Remove the access panel
3. Install four black and blue M3 isolation mounting guide screws (two on each side of the drive).
NOTE:
When replacing a drive, transfer the four mounting screws from the old drive to the new drive.
44 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
(Access panel on page
M3 metric isolation mounting guide screws can be purchased from HP.
Installing a 2.5-inch hard drive on page
(Preparation for disassembly on page
19).
44. If you are not
18).