Table of Contents
Advertisement
Transmission temperature
2.1.3.
When the temperature is under 40 C the display shows
---LO--- and when over 40 C it shows the temperature. If
the temperature rises over 90 C, clean the radiator and
check the gearbox oil level.
Position of lower links %, 0---100 AC
2.1.4.
The display shows symbol AC and the position of the
lower links as a percentage scale 0 --- 100. 0 = the lower
links are in the lowest position and 100 = the lower links
are in the top position. When the lower links are in the
middle position, the display shows the number 50.
Functions on the bottom line
2.2.
Maintenance schedule
2.2.1.
When the tool symbol and periodic maintenance hour
number are illuminated in the display, the appropriate ser-
vice work has to be carried out by an authorized work-
shop. If this work is not carried out, the tool symbol and
periodic maintenance hour number are shown for 10 sec-
onds whenever the ignition is switched on. When the ser-
vice has carried out this warning will be deleted by simul-
taneously pressing the low side of the change over switch
(2.8.1) and switching the ignition on. The tool symbol will
illuminate again when the next service interval has been
reached.
When the power is switched on, the last display is shown
in the display unit.
2.3.
69---25,6
69---25,9
--- Choose the driving trip on the display by pressing the
upper side of the change over switch for LCD---display
unit (2.8.1).
--- Then press and hold down the low side of the change
over switch (2.8.1) until the display is zero.
The maximum display is 999.9 km.
69---25,7
69---25,91
If the setting mode is not altered for over 10 seconds, the
display changes into the normal mode.
--- With the power switched on and the clock function se-
lected, press and hold the upper side of change over
switch for LCD---display unit (2.8.1) for over 3 seconds.
The display is in the setting mode when the minutes
start to flash.
--- Set the minutes by pressing the low side of the change
over switch (2.8.1). By keeping the low side pressed
down the numbers change continuously.
69---25,8
--- To change the hours press the upper side of the change
over switch (2.8.1).
--- Set the hours by pressing the low side of the change
over switch (2.8.1).
The new time is set and the display goes into "normal"
mode after about 10 seconds without making any
changes or by pressing the upper side of the change over
switch (2.8.1) for over 3 seconds.
---33---
Resetting driving trip to zero
2
.8.1
Resetting time
2.4.
2
.8.1
D. Instruments and controls
Advertisement
Table of Contents
