Table of Contents
Advertisement
Lift/lower indicator lights (1
D 2.4.1.4.
1
1
.4
.5
1
.4
The lift indicator (red = lift) is lit when the lower links are
lifting, the lowering indicator (green = lowering) is lit when
they are lowering. Neither indicator is lit when the links are
stationary.
Lowering speed selector (1
D 2.4.1.5.
There are nine different positions available. The lowering
speed is increased when this knob is turned clockwise. A
slow lowering speed should be selected with heavy
implements. The lowering speed is independent of the
load.
Transport height selector (1
D 2.4.1.6.
The transport height (i. e. the upper position of the lower
links) is increased when this knob is turned clockwise.
Nine different positions are available. This knob limits the
lifting height when either the position control knob (1.2) or
the lift/stop/lower switch (1.3) is used. The height limit is a
useful feature when there is a danger that the implement
could hit the cab, etc.
CAUTION: This knob does not limit lifting height when
the push buttons in the cab or on the mudguards are
used.
NOTE: To quickly stop the lowering movement of the
lower links, press the lift or lower button.
)
.4
1
1
.6
.7
1
.9
)
.5
)
.6
D 2.4.1.7.
1
1
1
.8
.4
1
.4
69---31,1
This knob should be turned to the P position when the
position control is being used (base position). This
ensures that the linkage will remain in the selected
position without draft control. When draft control is used
(e.g. when ploughing/plowing) the knob should be turned
to one of the six (1 ---6) sensitivity levels.
Drive balance control switch (1
D 2.4.1.8.
Drive balance control switch has two positions and is used
when transporting heavy implements on the linkage. It is
used for balancing the tractor when driving. The system
only operates in the transport position, in other words
when the lift/stop/lower switch is in the lift position.
The balance control system begins to work when driving
the tractor. In this case the linkage lowers automatically
about 4 % (it can be seen on the lowering light). So that
the linkage has enough movement in both direction. The
linkage has to be high enough to accommodate these
movements.
When the vehicle stops, the balance control system stops
functioning and the linkage rises to the starting position
(visable on the lifting light).
D 2.4.1.9.
When the drive balance control is ready for work, the light
is on.
---41---
Draft control selector (1
1
.5
.6
Drive balance control light (1
D. Instruments and controls
)
.7
1
1
.7
.8
1
.9
69---31,1
)
.8
)
.9
Advertisement
Table of Contents
