Table of Contents
Advertisement
32
en | Connection
Notice!
The heater in an outdoor AUTODOME unit cannot be powered via the Power-over-Ethernet +
(IEEE 802.3at, class 4) standard, unless the heater is connected to a High PoE Midspan 60W,
Single port (sold separately). See the Installation Manual of the Midspan for details.
Cable Type
Maximum Distance
Bandwidth
High PoE (required for pendants in outdoor applications that use
heaters)
PoE+ (only for indoor models or indoor applications for pendant model
where heater is not required)
Terminal Connector
Notice!
Consult the National Electrical Code (NEC) for cable bundling requirements and limitations.
10.4
Fiber Optic Ethernet Media Converter (Optional)
The fiber optic media converter is designed to transmit 10/100 Mbps Ethernet signals over
fiber optic cable using 10/100 Mbps Small Form-factor Pluggable (SFP) modules. The SFP
modules are available as multi-mode fiber (MMF) or single-mode fiber (SMF) models with a
single SC connector or dual-fiber with an LC connector. Refer to the VG4-SFPSCKT Fiber Optic
Media Converter Installation Guide.
Ethernet Media Converter
Data Interface
Ethernet
Data Rate
10/100 Mbps
IEEE 802.3 Compliant
Full Duplex or Half Duplex Electrical Port
Full Duplex Optical Port
Fiber Type, MMF
50/125 µm MMF. For 50/125 µm fiber, subtract 4 dB from the specified optical budget
value. Must meet or exceed fiber standard ITU-T G.651.
Fiber Type, SMF
8–10/125 µm SMF. Must meet or exceed fiber standard ITU-T G.652.
Maximum Distance
20 km (12.4 miles)
Requirement
Media converter receiver (CNFE2MC/IN) at controller end of system
Terminal Connection Duplex LC or Single SC
2019-09 | 0.8 |
Installation Manual
AUTODOME IP starlight 7000i
CAT-5E or CAT 6 Ethernet
100 m (328 ft)
10 Base-T/100 Base-TX
Use the Bosch High PoE 60W midspan
(sold separately).
IEEE 802.3at, class 4 standard
RJ45, Female
Bosch Security Systems
Hide quick links:
Advertisement
Table of Contents
