Accessible Ip Settings - Moxa Technologies NPort 5110 Series User Manual

NPort 5110 Series User's Manual
TCP port
Setting
1 to 65535
The TCP port that other devices must use to contact this device. To avoid conflicts with standard
TCP ports, the default is set to 4001.
TCP alive check time
Setting
0 to 99 min
0 min: TCP connection is not closed due to an idle TCP connection.
1 to 99 min: NPort 5110 automatically closes the TCP connection if there is no TCP activity for
the given time.

Accessible IP Settings

NPort 5110 uses an IP address based filtering method to control access to itself.
Accessible IP Settings allows you to add or block remote host IP addresses to prevent
unauthorized access. Access to NPort 5110 is controlled by IP address. That is, if a host's IP
address is in the accessible IP table, then the host will be allowed to access the NPort 5110. You
can allow one of the following cases by setting the parameter.
! Only one host with a specific IP address can access the NPort 5110
Enter "IP address/255.255.255.255" (e.g., "192.168.1.1/255.255.255.255").
! Hosts on a specific subnet can access the NPort 5110
Enter "IP address/255.255.255.0" (e.g., "192.168.1.0/255.255.255.0").
Web Console Configuration
Factory Default
4001
Factory Default
7 min
5-25
Necessity
Required
Necessity
Optional