Network Setting - Minolta Bizhub 36 Installation Manual

XXV. Network setting
Make the TCP/IP address setting for the network.
Note:
The IP address is assigned automatically by the
DHCP server, when the machine's power is turned
ON. (DHCP setting at the time of factory shipment:
ON)
<To Set Manually>
If the machine's IP address is not set automatically,
follow the steps below to set it manually.
Note:
Consult the network adminisutrator for the setting
value to be entered and make settings as
required.
1. Press the [Utility/Counter] key.
2. Touch "Admin Settings".
word. Touch "OK".
3. Touch "Ethernet" "TCP/IP"
"OFF" "OK".
4. Set the following settings:
(1) Touch "Enable"
(2) Touch "IP Address".
on the network of the machine.
(3) Touch "Subnet Mask".
Touch "OK".
(4) Touch "Gateway".
Touch "OK".
5. Turn OFF the Power Switch, then turn it back ON.
6. Press the [Utility/Counter] key.
7. Touch "User Settings"
Reports" "Configuration Page"
"OK", to print the settings list page, and verify that
the settings from step 4 have been completed
correctly.
Enter Admin pass-
"DHCP"
"ON" "OK".
Set it to an IP address
Touch "OK".
Set the subnet mask.
Set the gateway address.
"Print Settings" "Print
"Print"
E-14