Table of Contents
Advertisement
XX. Install date
1. Display the Service Mode screen.
(For details of how to display the Service Mode
screen, see the service manual.)
2. Touch "System Settings"
3. Touch "Installation Date".
4. Touch "Delete", and enter the year/month/day
using the numeric keypad.
5. Touch "OK"
"Register".
6. Touch "Close" twice.
XXI. Unit change
Note:
This function allows the user to select the type of
message that will appear when the replacement
time arrives for each of the different units.
1. Make sure that the Service Mode screen is dis-
played.
2. Touch "Toner Change".
3. Touch "User" or "Service".
4. Touch "OK".
"Installation Date".
E-12
XXII. Adjusting registration of paper
source options
1. Load trays 4 and 5 with A4 or Letter size papers.
2. Make sure that the Service Mode screen is dis-
played.
3. Touch "Printer Adjustment".
<Leading Edge Adjustment>
1. Touch "Side Edge Adjustment" "Tray 4"
2. Press the [Start] key.
A test print will be produced.
3. Measure widths B and C of the pattern on the test
printout, and check that the difference is within
the specified range.
Specifications: Width B - Width C = 0 ± 1.0 mm
4. If the difference between the measured widths B
and C is outside the specified range, enter the
correction value using the
Adjustable range: -3.0 to +3.0 mm
(Step: 0.2 mm)
Paper exit
direction
B
5. Print a test page again, and check if the differ-
ence is within the specified range.
* If the use of the
the measurement to fall within the specified
range, perform the following steps.
6. Slide out the drawer and unload paper from it.
7. Loosen the three screws shown in the illustration.
or
key.
C
A3EWPCA008AA
or
key does not allow
A0XWMXC018MB
Advertisement
Table of Contents
