Minolta Bizhub 36 Installation Manual page 10

4. Open the front door and slide the toner hopper
out of the machine.
5. Remove the protective tape.
6. Open the toner holder and mount the toner bottle.
Note:
Place the toner bottle so that its seal surface faces
upward.
7. Close the toner holder.
Place the surface to which
the seal is adhered upward.
Toner holder
8. Gently peel off the seal toward you from the bot-
tle.
Note:
Perform this procedure slowly, as toner can burst
out when the seal is peeled off.
A1UDIXC015DA
9. Slide the toner hopper back into the machine until
it clicks into position. Then, close the front door.
A1UDIXC037DA
XVII. Adjusting touch panel
1. Press the [Utility/Counter] key.
2. Touch "Accessibility"
ment".
3. Lightly touch the center of the "+" markers at four
places on the touch panel. (Touch in any order.)
Note:
Pressing the touch panel hard may cause dam-
age.
* When all the markers at four places have been
touched, the [Start] key turns blue and lights up
steadily blue.
4. Press the [Start] key.
A1UDIXC016DA
5. Touch "Close."
E-10
A1UDIXC017DA
A3EW11A019AA
"Touch Panel Adjust-