Mounting And Operation; Battery Charging; Charging Procedure - Bosch ALB 36 LI Original Instructions Manual

OBJ_BUCH-2071-003.book Page 5 Wednesday, November 20, 2013 11:09 AM
Technical file (2006/42/EC, 2000/14/EC) at:
Bosch Lawn and Garden Ltd., PT-LG/ENS4,
Stowmarket, Suffolk IP14 1EY, England
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
24.09.2013

Mounting and Operation

Action
Delivery Scope
Attaching Nozzle

Battery Charging

Inserting the battery
Battery Charge Indicator
Starting
Stopping
Working Advice
Maintenance and Cleaning
Storage and Transport
Selecting Accessories
Starting
For Your Safety
 Before any work on the garden product itself (e. g.
maintenance, tool change, etc.) as well as during trans-
port and storage, remove the battery from the garden
product. There is danger of injury when unintentionally ac-
tuating the On/Off switch.
 The machine continues to blow for a few seconds after
being switched off. Allow the motor to stop rotating be-
fore switching "on" again.
Do not rapidly switch off and on.
Battery Charging
 Do not use other battery chargers. The supplied battery
charger is designed for the Lithium-Ion battery in your gar-
den product.
 Observe the mains voltage! The voltage of the power
supply must correspond with the data given on the name-
plate of the battery charger. Battery chargers marked with
230 V can also be operated with 220 V.
Bosch Power Tools
The battery is equipped with temperature monitoring that al-
lows charging only in the temperature range between 0 °C
and 45 °C. In this manner, a high battery service life is
achieved.
Note: The battery is supplied partially charged. To ensure full
capacity of the battery, completely charge the battery in the
battery charger before using your power tool for the first time.
The lithium-ion battery can be charged at any time without re-
ducing its service life. Interrupting the charging procedure
does not damage the battery.
The "Electronic Cell Protection (ECP)" protects the lithium ion
battery against deep discharging. When the battery is run
down or discharged, the garden product is shut off by means
of a protective circuit. The gun speed drops instantly to signi-
fy the battery requires charging.
Figure
1
been automatically switched off. The battery can be dam-
2
aged.
3

Charging Procedure

3
The charging procedure starts as soon as the mains plug of
the battery charger is plugged into the socket outlet and the
4
battery is inserted into the charging compartment.
5
Due to the intelligent charging method, the charging condi-
tion of the battery is automatically detected and the battery is
5
charged with the optimum charging current, depending on
6
battery temperature and voltage.
7
This gives longer life to the battery and always leaves it fully
charged when kept in the charger for storage.
7
Rapid-charging Procedure
8
The rapid-charging procedure is indicated by flashing of the
green charge control LED.
Indication element of the battery: During the charging proce-
dure, the three green LEDs light up one after the other and
briefly go out. The battery is fully charged when the three
green LEDs light up continuously. The three LEDs go out again
approx. 5 minutes after the battery has been fully charged.
Note: The rapid-charging procedure is only possible when the
battery temperature is within the allowable charging temper-
ature range, see section "Technical Data".
English | 5
Do not continue to press the On/Off
switch after the garden product has
AL 3640 CV
Professional
AL 3620 CV
Professional
F 016 L70 963 | (20.11.13)