Mounting The Loop Handle; Mounting The Deflector - Stihl FSA 90 R Instruction Manual

Mounting the Loop Handle

Mounting the Loop Handle
7
7
8
8
4
3
5
6
1
1
Place the clamp (3) in the loop
N
handle (4) and position them both
against the shaft (5).
Position the clamp (6) against the
N
shaft.
Line up the holes.
N
Fit washers (8) on the screws (7)
N
and insert the screws in the holes.
Fit the square nuts (1) and screw
them down as far as stop.
Go to "Adjusting and Securing the
N
Loop Handle".
FSA 90 R
Adjusting and Securing the Loop Handle
A
4
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance "A".
Distance A when using mowing heads:
Max. 30 cm (12 in)
Slide the handle to the required
N
position.
Line up the loop handle (4).
N
Tighten down the screws so that the
N
handle cannot be rotated on the
shaft.

Mounting the Deflector

1
Position the deflector against the
N
motor housing.
Push hooks (1) on deflector into the
N
recesses in the motor housing.
Insert the screw (2) and tighten it
N
down firmly.
English
2
15