Mounting The Loop Handle; Mounting The Cutting Blade - Stihl FC 56 C Instruction Manual

Mounting the Loop Handle

Your new power tool comes with the
loop handle mounted on the drive tube,
but it must be turned and lined up to suit
your requirements.
Adjusting the Loop Handle
1
Loosen the star knob (1).
N
Turn the handle to the vertical
N
position.
FC 56 C
A
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommended distance (A): about 6 in
(15 cm)
Slide the handle to the required
N
position.
Tighten down the star knob so that
N
the handle cannot be rotated on the
drive tube.

Mounting the Cutting Blade

Place the edger so that the blade
N
mounting (1) faces upwards
5
6
4
2
3
Insert the locking pin (2) as far as
N
possible into the bore (3), push
lightly and rotate back and forth a
little together with the thrust washer
(4) until the shaft is blocked.
Fit Allen wrench (5) onto nut (6).
N
English
15