Table of Contents
Advertisement
2-4 StorageWorks Fibre Channel Storage Switch User's Guide
Power Requirements
Selecting a Switch Mounting Method
Placing the Switch on a Surface (Table-top
Mounting)
You connect the ac power cord to a switched connector on the bottom right
side of the Switch front panel. The ac power source must meet these
requirements:
A properly–wired, earth–grounded ac outlet
Voltage capability of 90–134 Vac or 180–257 Vac, and IEC 801-5 surge
voltage
Input voltage frequency of 50–60 Hz
Power capability of 219 watts, maximum.
The Switch has an autoranging power supply that automatically accepts
voltages within its range. There is no provision for surge protection built
into the Switch power supply so the ac source should include provisions to
assure clean ac power.
The Switch can be placed on a table top or other surface, or it can be mounted
in an equipment rack.
You can set the Switch on a surface, such as a table top, and operate it from
that location. Although adhesive rubber feet are included in the Installation
Kit, they are not necessary for proper or safe operation of the Switch. If you
want to install the rubber feet, perform these steps:
Use the alcohol wipes to clean the depression in each corner of the
bottom of the chassis; allow the alcohol to dry.
Remove the rubber feet from the sheet and insert one in each depression.
Press the rubber feet in place firmly.
Advertisement
Table of Contents
