Advertisement
Installation Instructions
The following instructions are written with the assumption that the GraphXMaster
display wall is properly built and display cubes are secure.
Tools Required:
◊
wrench (to tighten screen bolts)
◊
1mm nylon spacers (for screen spacing)
◊
cotton gloves for handling screens
STEP 1 – Remove screen from packaging.
STEP 2 – Install center screen – It is
recommended that you begin installing
screens at the center and work outward.
Working in pairs, lift the screen straight
up and over the opening in the cube.
Hook it over the two extruding screws
on the front frame. With one person still
supporting the screen at the front, insert
the four long threaded rods into the
screens mounting holes and hand-
tighten only. (Figure 1.) NOTE: Small
screws used to secure top of screen, as
shown in Figure 1. is for the top row of
only.
STEP 3 – Install adjacent screen – Lift an
adjacent screen into place (same as
center). Slide several 1mm nylon
spacers between the two screens to
ensure an even gap. Check to ensure
screens are level and the gap between
them remains even at 1mm. Adjust
screens as necessary. (Figure 3.)
STEP 4 – Tighten screws between two screens – torque setting of 8.5ft
Screen Handling & Installation Instructions
Page 2 of 8
Figure 1. Install Screen
•
lb.
Advertisement
