Operation Using The Remote Controller; Preparation - Sony SRG-300SE Ipela User Manual

Operation Using the Remote
Controller
This section explains the operations of the camera using
the remote controller.
When you make the settings of the camera using the
remote controller, see "Setting with the Remote
Controller" on page 51.
When you operate the camera via a network, see
"Operating the Camera Via a Network" on page 10.
Before operating, check that the camera, the remote
controller, and peripheral devices are properly installed
and connected.
For details, see "Installation Manual" and "System
Configuration" on page 6.
Notes
• The connection of the camera and the remote
controller is available for RS-422 connection only. Set
the communication speed of the VISCA RS-422
connector of the connected camera to be the same
speed of the remote controller. For details, see
"Setting the Camera Via a Network" - "Setting the
PTZF control — PTZF control Menu" - "Serial Tab"
on page 42.
• Do not operate the camera via a network or use the
remote controller at the same time.
• When performing the IP output of video and audio, the
response of the camera to operation from the remote
controller may delay.
46

Preparation

Preparation
1 2
RESET
JOYSTICK
VALUE LOCK
BLACK PAN-TILT
POSITION GROUP
LIGHT RESET
KNOB
RESET
– +
R
PRESET GROUP POSITION
MODE
BRIGHT
1 2 3 4
SHIFT
9 10 11 12
– + GROUP
B
SELECT
CAMERA
AUTO
FOCUS
AUTO 1 2 3 4
POWER
MANUAL
ONE PUSH
NEAR FAR AF
POWER CAMERA
1
Connect the camera to an AC outlet using the
supplied AC power adaptor.
The power is turned on and the POWER indicator
and the NETWORK indicator lights or flashes.
About 2 minutes after turning on the power, the
camera will automatically reset to the pan/tilt
position and the camera settings stored in
POSITION 1 (Preset 1).
For the setting items retained in the memory when
starting the camera, see "Preset Items" on page 62.
2
Press the ON/OFF switch on the remote controller
to turn it on.
The CAMERA button representing the camera
whose power was turned off last lights.
(The CAMERA 1 button lights by default.)
3
Turn on the peripheral devices.
Notes
• Be sure to turn on the power of the camera before the
power of the remote controller. Otherwise, the remote
controller may not recognize the connected camera.
• After turning on the power of the camera, wait more
than two minutes and turn on the power of the remote
controller. Otherwise, the connection may not be
recognized. Also, you cannot turn on/off the power of
the camera from the remote controller.
ONE PUSH
MENU
AWB
5 6 7 8
13 14 15 16
5 6 7