Table of Contents
Advertisement
F
INISHING THE
Step 1. Tuck connections neatly into ceiling outlet box.
Step 2. Slide the canopy up to mounting bracket and place
the key hole on the canopy over the screw on the mounting
bracket, turn canopy until it locks in place at the narrow
section of the key holes.
Step 3. Align the circular hole on canopy with the remain-
ing hole on the mounting bracket, secure by tightening the
two set screws. Note:
Note: Adjust the canopy screws as necessary
until the canopy and canopy cover are snug.
WARNING: Make sure the hook on the hanging bracket
WARNING:
properly sits in the groove in the hanger ball before attach-
ing the canopy to the bracket by turning the housing until it
drops into place.
B
A
LADE
TTACHMENT
CAUTION:
CAUTION: Remove 5 rubber packing mounts from fan
motor assembly and discard before installation.
1. Place fiber washer on screw. Insert this assembly
through the blade and start the screw into the blade arm.
Repeat this procedure without tightening the screw until
all 3 screws have been started into the blade arm.
2. Tighten each screw starting with center screw.
3. Fasten blade assembly to motor with provided screws
and lockwashers. Repeat procedure for remaining blades.
Make sure screws are TIGHT! Loose motor screws can
contribute to unnecessary hum during operation.
NOTE: Cordless power screwdrivers are NOT recom-
NOTE:
mended, as they tend to strip the heads of the screws and
usually will not fully compress the lock washers on the
motor screws. Use a large flat blade screwdriver for final
tightening to fully compress the washers. This will help
ensure proper alignment of the blades and noise-free,
wobble-free running.
I
NSTALLATION
Hanging
Bracket
Canopy
Canopy Screw
Cover Plate
Screws
8
Ceiling Fan
Outlet Box
Screws
Fiber
Screws
Washers
Blade Arm
Advertisement
Table of Contents
