Turning On The Dvr; Turning Off The Dvr - PACOM PDR16HR-RMT-RT User Manual

Audio Out: Connect an amplifier (Line-out). The DVR does not have amplified audio output, so you will need a
speaker with an amplifier.
VGA (D-Sub): Connect an HD (high-definition) PC monitor which supports a D-Sub interface. Connect a monitor
before turning on the system. Video might not be displayed on the monitor when connecting a monitor after turning
on the system.
DVI: Connect an HD (high-definition) PC monitor which supports a DVI interface.
E-SATA: Connect an external hard disk drive which supports an eSATA interface.
HDMI: Connect an HD (high-definition) PC monitor which supports an HDMI interface.
USB: Connect USB devices such as a mouse, keyboard, USB storage device or printer.
Network (RJ-45): Connect a Cat5 cable with an RJ-45 connector. The network settings are available at the SYSTEM
– Network menu of SmartGuard.
NOTE: The location of ports in slots can be different from the image above. Refer to Appendix 4 — Connector
Pin Outs for connection of the ports located in slots.
NOTE: VGA, DVI and HDMI main out supports dual display (SmartGuard on the primary display and SmartSearch
on the additional display) and not triple display.
NOTE: Windows may not operate properly when using the USB connectors on the front panel of the DVR, depending
on the model type of the USB device. In this case, connect the USB device after Windows boots properly or use
the USB connectors located on the rear panel.
NOTE: When mounting the DVR on a rack, comply with the following instructions.
Ensure that the rack inside is not sealed.
Ensure the air is circulated through the inlet/outlet.
If you pile up DVRs or other rack-mount devices, secure room for ventilation or install a vent.
For natural air convection, place the inlet at the bottom of the rack and the outlet on top.
It is strongly recommended that a fan motor is installed at the inlet and the outlet for air circulation and fit a filter
at the inlet to screen dust or foreign substances.
Maintain the temperature inside the rack or surrounding areas between 41°F to 104°F (5°C to 40°C).

TURNING ON THE DVR

Press the power button located on the front panel to turn the system on. The system goes into the SmartGuard mode
as soon as it finishes its boot process.
NOTE: Connect a monitor before turning on the system. Video might not be displayed on the monitor when
connecting a monitor after turning on the system.
CAUTION: The DVR requires 1920 x 1080 resolution. The system will not boot if the monitor does not
have 1920 x 1080 resolution.

TURNING OFF THE DVR

Click the (Menu) button and System Shutdown menu of SmartGuard or press the power button on the front panel
to turn the system off.
NOTE: When turning off the system, you must confirm that you want to turn off the unit. Turning off the system
is allowed to only authorized users for the Shut down option during the
CAUTION: The system can be shut down by force by pressing the power button on the front panel over
10 seconds. However, follow the normal shutdown procedures as mentioned above when the system is
operating normally. Turning off the DVR without shutdown procedures can cause damage to the system.
Digital Video Recorder
at the USER menu of SmartGuard .
3