Timeout Between Decodes, Same Symbol; Beep After Good Decode - Motorola Symbol MS4404 Integration Manual

6 - 10 Symbol MS4404/MS4407 Integration Guide

Timeout Between Decodes, Same Symbol

Parameter # 89h
This option is used in presentation mode to prevent multiple reads of a symbol left in the Symbol MS440X field of
view. The timeout begins when the symbol is removed from the field of view. It is programmable in 0.1 second
increments from 0.0 to 9.9 seconds. The default interval is 0.6 seconds.
To select the timeout between decodes for the same symbol, capture the bar code below, then capture two numeric
bar codes from Appendix D, Numeric Bar Codes

Beep After Good Decode

Parameter # 38h
Capture a bar code below to select whether or not the imager issues a beep signal after a good decode. If selecting
Do Not Beep After Good Decode, beeper signals are issued during parameter menu imaging and to indicate
error conditions.
*
Beep After Good Decode
(Enable)
(01h)
that correspond to the desired interval, in 0.1 second increments.
Timeout Between Decodes, Same Symbol
Do Not Beep After Good Decode
(Disable)
(00h)