Chapter 7 Imager Preferences; Overview - Motorola Symbol MS4404 Integration Manual

Miniscan imager
Hide thumbs Also See for Symbol MS4404:
Table of Contents

Advertisement

Chapter 7 Imager Preferences

Overview

This chapter describes imager preference features and provides the programming bar codes for selecting these
features.
The imager ships with the settings shown in the
A, Standard Defaults
programming is not necessary.
There are two ways to change a parameter value:
Capture the appropriate bar codes in this guide. These new values replace the standard default values in
memory.
For SSI and USB SNAPI hosts, send a "parameter send" command from the host system. Hexadecimal
parameter numbers are shown in this chapter below the parameter title, and options are shown in
parenthesis beneath the accompanying bar codes. See the Simple Serial Interface (SSI) Programmer Guide
for detailed instructions for changing parameter values using this method.
NOTE Most computer monitors allow capturing the bar codes directly on the screen. When capturing from the
screen, be sure to set the document magnification to a level where the bar code can be seen clearly, and
bars and/or spaces are not merging.
Select a host type (see each host chapter for specific host information) after the power-up beep signal activates.
This is only necessary upon the first power-up when connected to a new host.
To return all features to default values, capture
code menus, default values are indicated with asterisks (
*
Indicates Default
for all host device and miscellaneous defaults). If the default values suit requirements,
*Set All Defaults on page
*
Enable Decode Aiming Pattern
Imager Preferences Default Table on page 7-2
6-3. Throughout the programming bar
*
).
Feature/Option
(02h)
Option Hex Value for
programming via SSI command
(also see
Appendix

Advertisement

Table of Contents
loading

This manual is also suitable for:

Symbol ms4407

Table of Contents