Simple Serial Interface Default Parameters - Motorola Symbol MS4404 Integration Manual

8 - 8 Symbol MS4404/MS4407 Integration Guide

Simple Serial Interface Default Parameters

This section describes how to set up the decoder with a SSI host. When SSI is used, the decoder is programmed
via bar code menu or SSI hosts commands.
Throughout the programming bar code menus, default values are indicated with asterisks (
*
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where the bar code can be seen clearly, and
bars and/or spaces are not merging.
Table 8-3 lists the defaults for the SSI host. There are two ways to change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
•
Download data through the device's serial port using SSI. Hexadecimal parameter numbers are shown in this
chapter below the parameter title, and options are shown in parenthesis beneath the accompanying bar
codes. See the Simple Serial Interface (SSI) Programmer's Guide for detailed instructions for changing
parameters using this method.
NOTE See
default parameters.
SSI Default Table
Table 8-3
Parameter
Select SSI Host
Baud Rate
Parity
Check Parity
Software Handshaking
Host RTS Line State
Decode Data Packet Format
Stop Bits
*
Baud Rate 9600
Indicates Default
Appendix A, Standard Defaults
Parameter
Number
N/A
9Ch
9Eh
97h
9Fh
9Ah
EEh
9Dh
Feature/Option
(06h)
Option Hex Value for programming
via SSI command
*Set All Defaults
for all user preferences, hosts, symbologies, and miscellaneous
Default
N/A
9600
None
Disable
ACK/NAK
Low
Send Raw Decode Data
1
*
).
bar code on page 6-3.
Page
Number
8-10
8-11
8-13
8-14
8-14
8-15
8-15
8-16