Polaris Ranger RZR 800 Manual page 284

FINAL DRIVE
4. Lift bearing carrier into place and install the bolt attaching
the bearing carrier to the upper A-arm. Torque fastener to
specification.
Upper Rear Bearing Carrier Bolt:
RZR: 33 ft. lbs. (45 Nm)
RZR S / RZR 4: 40 ft. lbs. (54 Nm)
5. Apply grease to drive shaft axle splines.
6. Install rear wheel hub assembly, cone washers, and hand
tighten the castle nut. Install washers with domed side out.
Cone Washers
Wheel
Hub
7. Install brake caliper mounting bolts and torque to 18 ft. lbs.
(24 Nm).
7.36
= T
Out
18 ft. lbs.
24 (Nm)
Rear Caliper Mounting Bolts:
18 ft. lbs. (24 Nm)
New bolts have a pre-applied locking agent
which is destroyed upon removal. Always use
new brake caliper mounting bolts
upon assembly.
8. Torque wheel hub nut to 80 ft. lbs. (108 Nm) and install a
NEW cotter pin. Tighten nut slightly if necessary to align
cotter pin holes.
80 ft. lbs.
(108 Nm)
Wheel Hub Castle Nut:
80 ft. lbs. (108 Nm)
9. Install wheel and (4) wheel nuts. Torque wheel nuts to
specification.
Wheel Nuts:
Steel Wheels: 27 ft. lbs. (37 Nm)
Aluminum Wheels: 30 ft. lbs. + 90° (1/4 turn)
= T
CAUTION
NEW Cotter Pin
= T
= T