Installation; Power Supply - Accentronix CELLSWITCH 100 User Manual

User Manual for Cellswitch 100

Power Supply:

Wiring Techniques
Wiring for the device has been designed to be safe and easy. If the user is concerned about the
correct installation of these products or associated products, please contact a professional
electrician who is trained to the local and national standards applicable to the installation site.
Wiring Cautions

Do not lay I/O signal cables next to power cables or allow them to share the same
trunking duct. Low voltage cables should be reliably separated or insulated with regard to
high voltage cabling.

Where I/O signal lines are used over an extended distance, consideration for voltage
drop and noise interference should be made.
0V +12V
POWER SUPPLY
12V / 500mA
General Specifications
Power supply (Regulated)
Max allowable momentary
power failure period
Average Power Consumption
at 12Vdc:
Average Power Consumption
at 5Vdc:
In-Rush Current

INSTALLATION

Minimum: 5Vdc 500mA
Maximum: 15Vdc 500mA
Less than 10ms
Output Off: 25mA (300mW)
Output On: 45mA (540mW)
Output Off: 40mA (200mW)
Output On: 45mA (540mW)
500mA
Page 7 of 23