1. Manuals
  2. Brands
  3. DeLonghi Manuals
  4. Cookers
  5. DRS 900-G
  6. User & installation instructions manual

DeLonghi DRS 900-G User & Installation Instructions Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
D E' LO N G HI
C OO KIN G
USER & INSTALLATION INSTRUCTIONS
D R S 90 0- G
GAS COOKER
GB

Advertisement

Table of Contents
loading

Related Manuals for DeLonghi DRS 900-G

Summary of Contents for DeLonghi DRS 900-G

  • Page 1 D E’ LO N G HI C OO KIN G USER & INSTALLATION INSTRUCTIONS D R S 90 0- G GAS COOKER...

  • Page 2: Table Of Contents

    CONTENTS Page Number Introduction ..........Important Safety Precautions &...

  • Page 3: Introduction

    Dear Customer, Thank you for purchasing the DeLonghi DRS 900-G gas cooker. The safety precautions and recommendations listed below are for your own safety and that of others. They will also provide a means by which to make full use of the features offered by your appliance.

  • Page 4: Important Safety Precautions & Recommendations

    IMPORTANT SAFETY PRECAUTIONS AND RECOMMENDATIONS IMPORTANT: This appliance is designed and manufactured solely for the cooking of domestic (household) food and is not suitable for any non domestic application and therefore should not be used in a commercial environment. The appliance guarantee will be void if the appliance is used within a non domestic environment i.e.
  • Page 5 • Do not touch the appliance with wet or damp hands (or feet). • Do not use the appliance whilst in bare feet. • If you should decide not to use this appliance any longer (or decide to substitute another model), before disposing of it, it is recommended that it be made inoperative in an appropriate manner in accordance to health and environmental protection regulations, ensuring in particular that all potentially hazardous parts be made harmless, especially in...
  • Page 6 • WARNING: Danger of fire: do not store items on the cooking surfaces. • WARNING: When correctly installed, your product meets all safety requirements laid down for this type of product category. However special care should be taken around the rear or the underneath of the appliance as these areas are not designed or intended to be touched and may contain sharp or rough edges, that may cause injury.

  • Page 7: Cooking Hob

    1 - COOKING HOB Fig. 1.1 GAS BURNERS 1. Auxiliary burner (A) 1,00 kW 2. Semi-rapid burner (SR) 1,75 kW 3. Rapid burner (R) 3,00 kW 4. Triple-ring burner (TR) 3,50 kW Notes: • The electric ignition is incorporated in the knobs. •...

  • Page 8: Control Panel

    2 - CONTROL PANEL Fig. 2.1 GAS OVEN OVEN LIGHT CONTROLS DESCRIPTION Front right burner control knob Rear right burner control knob Central burner control knob Rear left burner control knob Front left burner control knob 120’ alarm knob Gas oven / gas grill control knob Oven light control knob...

  • Page 9: Use Of The Hob Burners

    3 - USE OF THE HOB BURNERS GAS BURNERS Gas flow to the burners is adjusted by turning the knobs (illustrated in fig. 3.1) which control the safety valves. Turning the knob, so that the indicator line points to the symbols printed on the panel, achieves the following functions: - symbol closed valve...
  • Page 10 LIGHTING THE BURNERS CHOICE OF THE BURNER ignite burner, following On the control panel, near every knob instructions are to be followed: there is a diagram that indicates which burner is controlled by that knob. Press in the corresponding knob and The suitable burner must be chosen turn counter-clockwise (fig.

  • Page 11: Gas Oven

    4 - GAS OVEN THERMOSTAT The glass on the oven door reaches The numbers 1 to 10 printed on the control high temperatures during operation. panel (fig. 4.1) indicate the increasing oven Keep children away. temperature value (see table 4.2). Models with glass lid: The cooker lid The temperature is kept constant on the must be kept open when the gas oven/...
  • Page 12 IGNITION OF THE OVEN BURNER required. If the flame extinguishes for any reason, ATTENTION: Never turn the control the safety valve will automatically shut off knob before opening the oven door. the gas supply to the burner. To ignite the oven burner: To re-light the burner, first turn the oven Open the oven door to the full extent.

  • Page 13: Oven Cooking

    COOKING EXAMPLES For efficient oven preheating, we Temperatures are approximate as they recommend that grill tray and racks are vary depending on the quality and amount removed from the oven and replaced of food. after about 15 minutes. Remember to use ovenproof dishes and to adjust the oven temperature during cooking if necessary.

  • Page 14: Gas Oven

    IGNITION OF THE GRILL BURNER If the flame extinguishes for any reason, the safety valve will automatically shut off ATTENTION: Never turn the control the gas supply to the burner. knob before opening the oven door. To re-light the burner, first turn the grill To ignite the grill burner: control knob to position , wait for at...
  • Page 15 USE OF THE GRILL OVEN LIGHT Very important: The grill must always be The cooker is equipped with a light that used with the oven door slightly open illuminates the oven to enable visually and with shield “A” mounted (Fig. 4.7). controlling the food that is cooking. Mount shield “A”...

  • Page 16: Oven Temperature Guide

    5 - OVEN TEMPERATURE GUIDE Electric oven temperature Cooking process Oven heat Gas mark °C °F Keeping food hot, very cool ½ milk puddings Egg custards cool Rich fruit cakes, cool braising Low temperature moderate roasting, shortbread Victoria sandwich, plain fruit cake, moderate baked fish Small cakes, choux...

  • Page 17: 120 Minute Timer

    6 - 120 MINUTE TIMER 120 MINUTE TIMER (Fig. 6.1) The timer can be set to a maximum of 120 minutes and a buzzer will sound at the end of the countdown. The knob must be rotated clockwise as far as the 120 minute position first and then set to the required time by rotating it anticlockwise.

  • Page 18: Cleaning & Maintenance

    7 - CLEANING AND MAINTENANCE GENERAL ADVICE CLEANING • Before you begin cleaning, you • Stainless steel hob: Spillage on must ensure that the appliance is the hob can usually be removed by switched off at the cooker switch. a damp soapy cloth. More obstinate •...
  • Page 19 Inside of oven: The oven should BURNERS AND PAN SUPPORTS • always be cleaned after use when it These parts can be removed and cleaned has cooled down. The cavity should be as indicated previously. cleaned using a mild detergent solution After cleaning, the burners and their flame and warm water.
  • Page 20 Fig. 7.1 Fig. 7.2 Fig. 7.3 Fig. 7.5 Fig. 7.4...
  • Page 21 ASSEMBLY AND DISMANTLING OF Fig. 7.6 THE SIDE RUNNER FRAMES • Fit the side runner frames into the holes on the side walls inside the oven (Fig. 7.6). • Slide the rack and the tray into the runners (Fig. 7.7). The rack must be fitted so that the safety catch, which stops it sliding out, faces the inside of the oven (fig.
  • Page 22 Fig. 7.9 Fig. 7.10 OVEN DOORS STORAGE COMPARTMENT The internal glass panel can be easily The storage compartment is accessible removed for cleaning by unscrewing the through the pivoting panel (fig. 7.10). retaining screws (fig. 7.9). Do not use harsh abrasive cleaners or Do not store flammable material in the sharp metal scrapers to clean the oven oven or in the storage compartment.
  • Page 23 REMOVING THE OVEN DOOR The oven door can easily be removed as follows: • Open the door to the full extent (fig. 7.11a). • Open the lever “A” completely on the left and right hinges (fig. 7.11b). • Hold the door as shown in fig. 7.11. •...

  • Page 24: Advice For The Installer

    Advice for the installer IMPORTANT • The appliance is designed and approved for domestic use only and should not be installed in a commercial, semi commercial or communal environment. Your product will not be guaranteed if installed in any of the above environments and could affect any third party or public liability insurances you may have.

  • Page 25: Installation

    8 - INSTALLATION This cooker has class “2/1” overheating protection so that it can be installed next to a cabinet. If the cooker is installed adjacent to furniture which is higher than the gas hob cooktop, a gap of at least 200 mm must be left between the side of the cooker and the furniture. The walls and kitchen furniture surrounding the appliance must be made of non-flammable material.
  • Page 26 FITTING THE ADJUSTABLE FEET AND LEVELLING THE COOKER The adjustable feet must be fitted to the base of the cooker before use (figs. 8.2, 8.3). Rest the rear of the cooker on a piece of the polystyrene packaging exposing the base for the fitting of the feet.
  • Page 27 MOVING THE COOKER WARNING: When raising cooker to upright position always ensure two people carry out this manoeuvre to prevent damage to the adjustable feet (fig. 8.5). Fig. 8.5 WARNING WARNING Be careful: Do not lift the cooker by When moving cooker to its final position the door handle/s when raising to the DO NOT DRAG (fig. 8.7). upright position (fig. 8.6). Lift feet clear of floor (fig. 8.5). Fig. 8.7 Fig.
  • Page 28 STABILITY BRACKET We recommend a stability bracket is fitted to the cooker. The type shown in fig. 8.8 can be purchased from most plumbers merchants and do it yourself (D.I.Y.) shops. Existing slot in rear of cooker Brackets Dotted line showing the position of cooker when fixed Fig.

  • Page 29: Provision For Ventilation

    PROVISION FOR VENTILATION • The appliance should be installed into a room or space with an air supply in accordance with BS 5440-2: 2000. • For rooms with a volume of less than 5m - permanent ventilation of 100 cm free area will be required.

  • Page 30: Gas Installation

    9 - GAS INSTALLATION IMPORTANT NOTE This appliance is supplied for use on NATURAL GAS or LPG (check the gas regulation label attached on the appliance). • Appliances supplied for use on NATURAL GAS are adjusted for this gas only and cannot be used on any other gas (LPG) without modification.
  • Page 31 RESTRAINING CHAIN Fig. 9.1 Chain security holes Cooker Back of the cooker Rear wall Installation to Natural Gas Installation to Natural Gas must conform to the Code of Practice, etc. The supply pressure for Natural Gas is 20 mbar. The installation must conform to the relevant British/European Standards. Installation to LP Gas When operating on Butane gas a supply pressure of 28-30 mbar is required.
  • Page 32 Notes: • Flexible hoses can be used where the sited ambient temperature of the hose does not exceed 70°C. These hoses must be manufactured in accordance with BS669 part 1 and be of the correct construction for the type of gas being used. •...
  • Page 33 Fitting the plug Fig. 9.3 on the inlet pipe terminal not used Cooker manifold (right Cooker or left inlet pipe) manifold (right or left inlet pipe) Manifold male Manifold pipe fitting male 1/2” G cylindrical pipe fitting (ISO 228-1) male 1/2”...
  • Page 34 CONVERSION TO NATURAL GAS OR TO LPG REPLACEMENT OF THE INJECTORS Auxiliary, If the injectors are not supplied they can Semi-rapid and be obtained from the After-Sales Service. Rapid burners Select the injectors to be replaced according to the “Table for the choice of the injectors”.
  • Page 35 TABLE FOR THE CHOICE OF THE INJECTORS Cat: 2H3+ Natural Gas G30 28-30 mbar G20 20 mbar Nominal Reduced G31 37 mbar BURNERS power power Ø Air ring Ø Air ring [kW] [kW] injector opening injector opening [1/100 mm] [mm] [1/100 mm] [mm] Auxiliary (A)
  • Page 36 OPERATIONS TO BE EXECUTED FOR THE REPLACEMENT OF THE INJECTORS OF THE OVEN AND GRILL BURNER a) oven burner • Lift and remove the lower panel inside the oven. • Unscrew and remove the burner securing screw “A” (fig. 9.8). •...
  • Page 37 b) grill burner • Unscrew and remove the burner securing screw “C” (fig. 9.10). • Slacken screw “D” (fig. 9.10). • Move the burner in the manner shown in figure 9.11. Take care not to damage the wire to the ignition electrode and the safety valve probe.
  • Page 38 Fig. 9.12 REGULATION OF AIR SUPPLY TO OVEN AND GRILL BURNERS Using a cross-head screwdriver, slacken the screw “Q” securing the air flow regulation collar “P” (figs. 9.12 and 9.13) and turn the collar forward or backward to increase or reduce the air aperture in accordance with gas type and the indications in the ‘Table for the choice of the injectors’.
  • Page 39 ADJUSTMENT OVEN Flame faulty Flame with Flame BURNER MINIMUM in primary excess correct primary air This needs to be done only for the oven burner (the grill is a fixed capacity) by short and sharp long, yellow clear interior too blue interior acting on the thermostat.

  • Page 40: Electrical Installation

    10 - ELECTRICAL INSTALLATION 10 - ELECTRICAL INSTALLATION IMPORTANT: The appliance must be installed in accordance with the manufacturer’s instructions. Incorrect installation, for which the manufacturer accepts no responsibility, may cause damage to persons, animals or property. The connection of the appliance to earth is mandatory. The manufacturer declines all responsibility for any inconvenience resulting from the inobservance of this condition.
  • Page 41 ELECTRICAL FEEDER CABLE REPLACEMENT WARNING: If the power supply cable is damaged, it must be replaced only by an authorised service agent in order to avoid a hazard. To connect the supply cable: • Remove the screw securing the cover “A” on the rear of the cooker (fig. 10.2). •...

  • Page 42: Guarantee

    11 - GUARANTEE Your new “De’Longhi” product comes with 12-month guarantee covering all parts and labour. If your appliance proves to be defective as a result of faulty materials or workmanship during the guarantee period, these parts will be repaired or replaced free of charge. AFTER SALES SERVICE Should you require service, spares or product information and advice: •...
  • Page 44 D esc ri pt i o n s an d i ll ustrations i n this book let are gi ven a s s im p ly i nd ica ti ve . T he m an u f ac t u re r re serves the right, considering th e ch a ra cter is tics o f the model s d es c ri be d he re, at any ti me and wi thout notice, to ma ke even tua l n ecess a ry modifi c at i o n s f o r t he i r construction or for co mm erci al n eed s.

Table of Contents