Maintenance - Trojan IRONMAN 510 Care Instructions And Assembly Manual

6. MAINTENANCE

Your treadmill should require little maintenance other than to periodically apply lubricant. Lubricating under the
treadbelt will ensure superior performance and extend the treadmill's life expectancy.
HOW TO CHECK TREADBELT FOR PROPER
LUBRICATION
Lift one side of the treadbelt and feel the top surface of the
treadboard.
If the surface is slick to the touch, then no further lubrication is
required.
If the surface is dry to the touch, apply one packet of lubricant or
half of the bottle of lubricant.
HOW TO APPLY LUBRICANT
Lift one side of treadbelt.
Pour one half of the lubricant bottle under the centre of the treadbelt on the top surface of the treadboard.
Walk on the treadmill at a slow speed for 3 to 5 minutes to evenly distribute lubricant.
NOTE: DO NOT over lubricate treadboard. Any excess lubricant that comes out should be wiped off.
NOTE: ONLY USE HALF THE BOTTLE OF LUBRICANT PER APPLICATION
LUBRICATION SCHEDULE.
1. Check the treadboard lubrication during installation. If it's necessary, lubricate the treadboard, using the full bottle
of lubricant provided, before using the treadmill for the first time.
2. If the treadmill is used on a regular basis, the running deck should be lubricated once a month.
3. If the treadmill is not used for two months or more, the treadmill must be lubricated before use.
BELT TRACKING ADJUSTMENT
If during use you notice that the running belt either shifts to the right
or the left of centre, first remove "Safety Key" and unplug equipment
from AC power source. Using M6 Allen wrench provided, turn the
left rear roller adjustment clockwise no more the 1/4" of a turn.
Remove the M6 Allen wrench, insert the "Safety Key" and insert the
AC power cord into the AC outlet. Turn on your treadmill and
observe after running for a few minutes to see if the problem has
been corrected. This may take several adjustments, so repeat the
above procedure.
10195M-12