Check The Tires - Craftsman C950-52122-0 Owner's Manual

MAINTENANCE

CHECK THE TIRES

Check tires for damage. Check the air pressure in the tires with an
accurate gauge (see Figure 16).
CAUTION: Avoid Injury! Explosive separation of tire
and rim parts is possible when they are serviced
incorrectly.
• Do not attempt to mount a tire without the proper
equipment and experience to perform the job.
• Do not inflate the tires above the maximum pressure.
• Do not weld or heat a wheel and tire assembly. Heat can
cause an increase in air pressure resulting in an
explosion. Welding can structurally weaken or deform the
wheel.
• Do not stand in front or over the tire assembly when
inflating. Use appropriate tool that allows you to stand to
one side.
NOTICE: Check side of tire for maximum tire pressure. DO
NOT exceed maximum.
OFF-SEASON STORAGE
If the unit will be stored for thirty (30) days or more at the end of the
season, the following steps are recommended to prepare it for
storage. Always refer to the operator's manual for important details
if the unit is to be stored for an extended period.
NOTE: Fuel must be removed or treated to prevent gum
deposits from forming in the tank, filter, hose, and carburetor
during storage.
DANGER: Fire and Explosion Hazard
Gasoline is highly flammable and its vapors are explosive.
Fumes may travel to a distant ignition source and an explosion
and/or fire may result.
Handle gasoline carefully. Never store the unit, with fuel in the
tank, indoors or in a poorly ventilated enclosure where fuel
fumes could reach an open flame, spark, pilot light, such as a
furnace, water heater, or clothes dryer.
• Thoroughly clean the unit.
• Lubricate all lubrication points (see authorized dealer).
• Make sure all nuts, bolts, and screws are securely fastened.
Inspect all visible moving parts for damage, breakage, and wear.
Replace if necessary.
• Touch up all rusted or chipped paint surfaces; sand lightly before
painting.
• Cover the bare metal parts of the snowthrower housing auger,
and the impeller with rust preventative.
• If possible, store your unit indoors and cover it to give protection
from dust and dirt.
• If the machine must be stored outdoors, cover with a heavy
tarpaulin.
To Return to Service:
• Fill the fuel tank with a fresh fuel.
• Make sure all fasteners are tight.
• Make sure all guards, shields, and covers are in place.
20
Figure 16