Fuel - Hatz Diesel 1B20V Original Instruction Book

When adding oil or checking the oil level, the
engine must be horizontal.
6
– Remove oil filler screw „1" and dipstick „2".
7
– Add engine oil up to the MAX mark on dip-
stick.
Lubricating oil capacity: see Chapter 3.1.
– Insert the oil filler screw and tighten it (hand-
tight only).
Attention!
If the engine is operated while the oil level is
below the min. mark or above the max. mark,
it can cause damage to the engine.

4.1.2. Fuel

Stop the engine before refilling the fuel
tank. Never refuel near a naked flame
or sparks which could start a fire.
Don't smoke. Use only pure fuel and clean
filling equipment. Take care not to spill fuel.
All diesel oils which satisfy the following specifi-
cations are suitable:
EN 590 or
BS 2869 A1 / A2 or
ASTM D 975 -1D / 2D
Important !
The use of fuels of different specifications
requires the prior written consent of the HATZ
headquarters.
8
– Before the first start or if the fuel tank has
been run dry, completely fill the fuel tank with
diesel. The bleeding of the fuel system is auto-
matically.
9