Toyota 2007 Land Cruiser Owner's Manual page 42

SETTING THE SYSTEM
1. Turn the ignition key to the "LOCK"
position and remove it.
The indicator light will start flashing when
the key is removed from the ignition
switch. (See "Engine immobilizer system"
on page 12 for details.)
2. Have all passengers get out of the
vehicle.
3. Close and lock all the side doors, back
door and hood.
The indicator light will come on when all
the side doors, back door and hood are
closed and locked.
The system will automatically be set after
30 seconds. When the system is set, the
indicator light will start flashing again.
4. After making sure the indicator light
starts flashing, you may leave the ve-
hicle.
Never leave anyone in the vehicle when
you set the system, because unlocking
from the inside will activate the system.
WHEN THE SYSTEM IS SET
Activating the system
The system will sound the alarm under
the following conditions:
If any of the side doors is unlocked or
D
opened without the key or wireless re-
mote control key, or if the back door
or hood is forcibly opened
If the battery terminal is disconnected
D
and then reconnected
The indicator light will come on when the
system is activated.
If any of the side door or back door is
unlocked without the key or wireless re-
mote control key and the key is not in the
ignition switch, all the side doors and
back door will be automatically locked
again.
After one minute, the alarm will automati-
cally stop and the indicator light will starts
flashing again.
Reactivating the alarm
Once set, the system automatically resets
the alarm after the alarm stops.
The alarm will activate again under the
same circumstances described
"Activating the system".
Stopping the alarm
The alarm will be stopped by the following
two ways:
Start the engine, and the alarm stops
D
after 2 seconds.
Unlock any of the side doors or back
D
door with the key or wireless remote
control key.
These ways cancel the system at the
same time.
in
29