Toyota 2007 Land Cruiser Owner's Manual page 172

NOTICE
z Do not use liquid sealants for a flat
tire as tire pressure warning valve
and transmitter will be damaged.
z When the tires must be repaired or
replaced, have them repaired or re-
placed by the nearest Toyota dealer
or an authorized tire dealer. The
tire pressure warning valves and
transmitters will be affected by the
installation or removal of tires.
16C522a
IF THE TIRE PRESSURE
LIGHT BLINKS...
If the tire pressure warning light blinks
when the ignition switch is turned to
the "ON" position, the tire pressure
warning system is not working properly.
The system will be disabled in the follow-
ing conditions:
(When the condition becomes normal, the
system will work properly.)
D
If tires not equipped with tire pressure
warning valves and transmitters are
used.
D
If the ID code on the tire pressure
warning valves and transmitters is not
registered.
D
If electronic devices or facilities using
similar radio
nearby.
D
If a radio set at similar frequencies is
in use in the vehicle.
D
If a window tint that affects the radio
wave signals is installed.
D
If the tire pressure warning
switch is set to a different tire setting.
D
If there is a lot of snow or ice on the
WARNING
vehicle, in particular around the wheels
or wheel housings.
D
If non−genuine Toyota wheels are used.
D
If tire chains are used.
D
If the spare tire is in a location subject
to poor radio wave signal reception.
D
If the tire inflation pressure is 500 kpa
2
(5.1 kgf/cm or bar, 73 psi) or more
higher than the specified level.
If the tire pressure warning light blinks
frequently when
turned to the "ON"
checked by your Toyota dealer.
wave frequencies are
select
the ignition switch is
position, have it
159