Toyota 2007 Land Cruiser Owner's Manual page 235

Programming an entrance gate/Program-
ming all devices in the Canadian market
1. Decide which of the 3 HomeLink
tons you want to program.
2. Place your hand−held gate/device
transmitter 25 to 75 mm (1 to 3 in.)
away from the surface
R
HomeLink .
Keep the indicator light
R
HomeLink in view while programming.
3. Press and hold the
R
HomeLink button.
4. Continuously press and release (cycle)
the hand−held gate/device transmitter
button every two seconds until step 5
is complete.
5. When the indicator light
R
HomeLink changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
6. Test the operation of the HomeLink
pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
R
maining HomeLink button to program
another device.
222
Programming other devices
To program other devices such as home
R
but- security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
of the
R
Individual HomeLink
erased, however, to reprogram a single
on the button, follow the procedure "Programming
R
the HomeLink ".
selected (b) Operating the HomeLink
To operate the HomeLink
R
propriate HomeLink
programmed device. The HomeLink
cator light should
R
HomeLink continues to send the signal
for up to 20 seconds as long as the but-
on the
ton is pressed.
R
by
buttons cannot be
R
R
, press the ap-
button to activate the
(c) Erasing
R
indi-
memory (all three programs)
come on. The
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
memory.
19C517
R
the entire HomeLink
R