Table of Contents
Advertisement
Power On/Off Operation
Power Loss shut down
A low power shut down occurs when W24 senses that the external power supply is below the
minimal operating limit. The module will respond by powering down automatically without
notice.
This form of power-down is not recommended for regular use since the unexpected power loss
may result in loss of data.
Turning the W24 Off Using AT+iMRST
The AT+iMRST command initiates a W24 system reset operation, which powers off the W24.
This command emulates the ON_N signal operation for W24 power off.
Note:
16
In Stacked configuration, AT+iMRST powers down W24 only. It does not power down
the G24 or any similar module.
Module Hardware Description
May 31, 2008
Advertisement
Table of Contents
