Regulatory Requirements; Regulatory Statement (Safety) - Motorola W24 Technical Information

Regulatory Requirements

Regulatory Requirements
The Federal Communications Commission (FCC) requires application for certification of digital
devices in accordance with CFR Title 47, Part 15 Sub Part C ,section 15.247 and Part 15 Sub Part
B sections 15.107,15.109. This includes MPE calculation. As the W24 modem is not a standalone
transceiver but is an integrated module, the W24 cannot be tested by itself for EME certification.
It is, however, the integrator's responsibility to have the completed device tested for EME
certification.
Caution:

Regulatory Statement (Safety)

The following safety precautions must be observed during all phases of the operation, usage,
service or repair of any cellular terminal or mobile incorporating the W24 module. Manufacturers
of the cellular terminal are advised to convey the following safety information to users and
operating personnel, and to incorporate these guidelines into all manuals supplied with the
product. Failure to comply with these precautions violates safety standards of design,
manufacture and intended use of the product. Motorola assumes no liability for customer failure
to comply with these precautions.
The W24 must be operated at the voltages described in the technical documentation
•
The W24 must not be mechanically or electrically changed. Use of connectors should follow
•
the guidance of the technical documentation
The W24 is designed to meet the spectrum requirements of ETS 300328
•
The W24 has been partially tested to EN301489-17, since compliance to ESD requirements
•
will depend critically on the integration into the host device
When integrating the W24 into a system, Motorola recommends testing the system to
•
EN301489-17
The W24 meets the safety requirements of EN60950
•
Systems using the W24 are subject to mandatory EMC testing under directive 89/336/EEC
•
(see link below). Other directives, such as the LVD directive 73/23/EE, may also apply to a
system using the W24 module
http://ec.europa.eu/enterprise/newapproach/standardization/harmstds/reflist.html
Host Label Requirement
A readily visible label is required on the outside of the host that state i.e. "FCC ID:
IHDT56DB2/IC ID: 109O-DB2 is contained within", provided the host is within the limits of the
module grant. You must not remove the label from embedded module.
FCC Notice to Users
Motorola has not approved any changes or modifications to this device by the user. Any changes
or modifications could void the user's authority to operate the equipment. See 47 CFR Sec. 15.21.
viii
Unauthorized repairs or modifications could result in permanent damage to the
equipment and void your warranty and your authority to operate this device under
Part 15 of the FCC Rules.
Module Hardware Description May 31, 2008