Loading Copy Paper - Panasonic UB-5320 Operating Instructions Manual

Loading Copy Paper

Loading Copy Paper
1 Set the power switch to on ( I ).
• " " will flash on the Multi-Copy/Error
Indicator when copy paper has run out.
• The screen will move to home position and
stop.
2 Push the door open button and open the
printer door.
• If there is any copy paper remaining in the
copy paper compartment, remove it.
Door
Open
Button
3 Open the printer door to position B and load
the copy paper roll with smooth side facing
up, then move the printer door to position A to
prevent paper roll from falling.
(Loosen about 15 cm as shown and load it.)
A
B
10
Copy paper
compartment
Smooth side
About
15 cm
Wrong direction
Note
• Use copy paper roll with a core diameter
of 25.4 mm (1 inch) or more. Using a copy
paper roll with a smaller core could cause
paper jams.
4 Pass the paper over the paper feed roller and
under the cutter cover, then through the output
port about 4 cm.
Close the printer door securely, using two
5
hands.
Note
• Once the door is closed, paper will feed and
automatically cut. Remove and discard the
small piece of paper.
Load a new roll when:
• Red bands become visible at the edge of the copy
paper.
• The Multi-Copy/Error Indicator flashes "
the printer door is closed properly.
Paper feed
roller
Cutter cover
About 4 cm
" even if