Placement Of The Mounting Plate - RCA RMW1636SS Owner's Manual

1. PLACEMENT OF THE MOUNTING PLATE

A.
REMOVING THE MICROWAVE
OVEN FROM THE CARTON/
ASSEMBLE THE MOUNTING
PLATE
1.
Remove the installation instructions, filters, glass
tray and the small hardware bag. Do not remove
the Styrofoam protecting the front of the oven.
2.
Fold back all 4 carton flaps fully against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
the Styrofoam.
Styrofoam
3.
Pull the carton up and off the oven.
4.
Remove and properly discard plastic bags.
5.
you will be able to assemble it take following
picture.
Wire-Mounting
Mounting-Plate
Installation Instructions
B.
Carton
1.
2.
3.
THE MICROWAVE MUST BE CONNECTED TO AT
LEAST ONE WALL STUD.
8
FINDING THE WALL STUDS
Wall Studs
Center
Find the studs, using one of the following
methods:
A. Stud finder–a magnetic device which locates
nails.
OR
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound. This
will indicate a stud location.
After locating the stud(s), find the center by
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs
should be 16" or 24" from this mark.
Draw a line down the center of the studs.