Attach Mounting Plate To Wall - RCA RMW1636SS Owner's Manual

A.
OUTSIDE TOP EXHAUST (Vertical Duct)
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Check Microwave Assembly
A4. Check Damper Operation
A5. Mount Microwave Oven
A6. Adjust Exhaust Adaptor
A7.
Connect Ductwork
A1.
ATTACH THE MOUNTING PLATE
TO THE WALL
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach
the plate to a wall stud.
1.
Remove the toggle wings from the bolts.
2.
Insert the bolts into the mounting plate through the
holes designated to go into drywall and reattach
the toggle wings to ¾" onto each bolt.
Installation Instructions
To use toggle bolts:
3.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly centered
under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.
4.
12
Spacing for Toggles More
Than Wall Thickness
Toggle Wings
Toggle
Mounting
Bolt
Plate
Wall
Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall to
mount the plate.
Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
Bolt End