Table of Contents
Advertisement
catch
fire.
DO
WAVEGUIDE COVER.
Odor Removal
Occasionally, a cooking odor may remain in the
oven. To remove, combine 1 cup water, grated
peel and juice of 1 lemon and several whole
The turntable and turntable support can be
removed for easy cleaning. Wash them in mild,
sudsy water; for stubborn stains use a mild
cleanser and non-abrasive scouring sponge as
described
above.
dishwasher-proof.
dishwasher. The turntable motor shaft is not
sealed, so excess water or spills should be
wiped up immediately.
Grease Filters
Filters should be cleaned at least once a month.
Never operate the fan or oven without the filters
in place.
Pull down slightly on the tab toward the front of
the oven and remove the filter. Repeat for the
other filter.
Soak the filter in a sink or dish pan filled with
hot water and detergent. DO NOT use
ammonia or other alkali; they will react with the
filter material and darken it.
Agitate and scrub with a brush to remove
embedded dirt.
Rinse thoroughly and shake dry.
Replace by fitting the filter back into the
opening.
Light
1. To replace light bulbs, first disconnect power
to the oven at the circuit breaker panel or by
unplugging.
2. To release cover, remove the screw on the
light cover. (See illustration.)
NOT
REMOVE
They
are
Use
upper
rack
THE
cloves in a 2-cup glass measuring cup. Boil for
several minutes using 100% power. Allow to
set in oven until cool. Wipe interior with a soft
cloth.
Turntable/Turntable Support
3. DO NOT USE A BULB LARGER THAN 30
WATTS.
Close light cover and secure with screw
removed in step 2.
also
CAUTION: Light cover may become very hot.
of
Do not touch glass when light is on.
Charcoal Filter
Charcoal
filter
recirculated installation. The filter should be
changed every 6 to 12 months depending on
use.
1. Disconnect power to the oven at the circuit
breaker panel or by unplugging.
2. Remove the louver mounting screw from the
top center of the louver and push down
carefully on the tab at each end of the louver
to disengage it. (See illustration.)
3. Pull the louver away from the unit.
4. Change the charcoal filter.
5. Carefully push the louver back into place and
replace the screw remove in step 2.
16
is
used
for
nonvented,
Advertisement
Chapters
Table of Contents
