Polaris 2003 Pro X Service Manual page 67

Disassembly, Cont.
9. Inspect water pump weep hole for signs of leakage
or blockage.
10. Remove crankshaft seal from housing by driving
seal to inside of housing. Replace seal if removed.
11. Remove water pump cover bolts and then remove
impeller nut. Slide shaft out back side.
12. Inspect bearings. Replace if necessary. Replace
mechanical seal using the special tools listed below.
Use the seal press to install a new mechanical seal
in cover with spring sleeve toward impeller housing.
Install seal guide over end of shaft and apply a light
film of grease to seal guide. Carefully install shaft
and bearings in cover.
washer, impeller, washer, and nut. Torque impeller
nut to 10 ft.lbs. (14Nm).
Water Pump Mechanical Seal Installation
Tool - 700/800 domestic engines:
8.9mm.
PN 2872389
Assemble 10x14mm
Inspect Weephole
ENGINE
2.35