Polaris 2003 Pro X Service Manual page 62

ENGINE
Assembly, Cont.
28. Install new cylinder head cover O-rings and install
cylinder head cover.
properly seated in grooves. Apply a light film of
grease to hold O-rings in place if necessary.
29. Loctite 242 to threads of head bolts and install.
30. Torque head bolts to specification outlined on page
2.3 of this chapter.
31. Torque cylinder base nuts outlined on page 2.3--2.4
of this chapter.
32. Install washers and water pump impeller as
shown and torque nut to 10 ft. lbs. (14 Nm).
Impeller Nut Torque:
10 Ft lbs (14 Nm)
2.30
Make sure O-rings are
3
7 1
4
11
8
CYLINDER HEAD - 440 Pro X
5
3
MAG
SIDE
1
7
CYLINDER BASE
440 Pro X
Washer
10.3x14x1mm
Engine side
Mechanical Washer
Seal .325x.75x.063
10
12
6
9
2
5
4
6
PTO
SIDE
2
8
10 ft.lbs.
(14 Nm)