Polaris 2003 Pro X Service Manual page 308

Spider Indexing, 4.20
Spider Roller Installation, 4.24, 4.25
Spider Roller Removal, 4.24
Spindle Centering, IFS, 6.14
Spring Data, 6.2–6.4
Springs, Dual Rate, 6.9
Sprocket Part Numbers, 5.4
Stator Diameter, 8.7
Stud Installation, 7.36
Suspension Lubrication, 7.29
T
Tap Drill Size, Metric, 1.17
Tap Drill Size, SAE, 1.17
Tempurature Coversion Chart, 1.16
Throttle Opening vs. Fuel Flow, 3.12
Throttle Synchronization, 3.16
Throttle Synchronization Mikuni TM---38,
TM---40, 3.22, 3.23
Throttle Valve, 3.3, 3.11
Timing Curve, Changing, 2.9
Timing Procedure, 8.6
TM 38/40 Jet Needle Overview, 3.4
Toe Adjustment, Final , 6.18
Torque Procedure, Radius Rod Ends, 6.12
Torque Procedure, Tie Rod Ends, 6.12
Torque Stop Adjustment, 4.45
Torsion Bar Asm, Adjustable, 6.6
Torsion Bars, 42.5 inch stance, 6.6
TPS (Throttle Position Sensor), 8.18, 8.19
TPS Adjustment, 8.20, 8.21
TPS Testing, 8.18, 8.19
Track Clip Replacement, 7.34
Optional Tracks, 5.5
ISR Optional Tracks, 5.5
Traction, 7.35, 7.37, 7.38
Trail Set Up, 92 Octane Fuel, 1.2
Troubleshooting, Carburetor, 3.31, 3.32
Troubleshooting, Engine, 2.64
Troubleshooting, Oil Pump, 2.57
Troubleshooting, Seat Harness, 8.13
Tunnel, Pro X, 5.6
U
Unregulated Voltage, 8.10
V
V.E.S. Assembly, 2.45
V.E.S. Cleaning, 2.44
Variable Exhaust System Springs, 2.46
VES Removal, 2.43
W
Walke Evans Shock Rebuilding, 7.16–7.19
Walker Evans Valve part Numbers, 7.19
Width, Maximum Set Up, 6.14
Wiring Diagram, 440 XC SP, 8.24, 8.25
Wiring Diagram, XCF SP, 8.23