Motor Lock; Q.battery Removal; Check-Out - Quickie QM-710 Owner's Manual

Q M- 7 10/7 15 HD/ 72 0
P. MOTOR LOCK
10
Disengage the motor lock when you need to manually push the chair.
(For example, in an emergency, or if batteries fail).
Do not disengage motor lock unless power to the chair is off.
•
• With either one or both locks released, the chair will not operate and the battery charge
indicator will flash 9 bars rapidly (if power to the chair is on.)
• Be aware that the chair will not have brakes in the free-wheel position.
• The person pushing the chair needs to have full control when motor lock is disengaged.
1. Release brake lever to push the chair manually
a. The motor lock (A) is attached to the rear section of the motors located towards the back
of the chair.
b. Push the motor lock down.
2. Engage brake lever to drive the chair
a. The motor lock (A) is attached to the upper rear section of the motors located at the back
of the chair.
b. Pull the motor lock lever up.
Q. BATTERY REMOVAL
To remove the batteries for transporting or servicing:
Remove Batteries
a. Remove the two knobs (B) securing the seat. Tilt the entire seat back until it rests on the
stop.
b. Remove the shroud cover by lifting up on it as shown (Fig. 13).
c. Disconnect both battery harnesses (red & black connectors).
d. Lift the battery from the compartment via the battery carrying straps.
Batteries may weigh up to 55 lbs. (25 kg). Care must be taken to avoid injury when lifting.
R. CHECK-OUT
Once the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories
should the checked to make sure they are also performing smoothly. After the wheelchair has
been set-up, be sure that the chair performs to ytour specified operational settings.
If the chair does not perform the way you expect it to, (according to specifications), turn your
wheelchair OFF immediately and contact your authorized supplier to re-program operational set-
tings using the RNET operating guide.
If you have any problems, follow this Procedure:
a. Review the Set-up, Adjustment, and use section and the Operating Guide to make sure the
chair was properly prepared.
b. If your problem persists, contact your authorized supplier. If you still have a problem after
contacting your authorized supplier, contact Sunrise Medical Customer service. See the
introduction page for details of how to contact the people who can help you.
WARNING
11 12 13 14
WARNING
17
VIII. USE AND MAINTENANCE
A
B
10
11
12
13
14
MK-100158 Rev. A